Operating instructions

A-4
SCSI REFERENCE 1012975
CHAPTER A—ERROR CODES
H/W Inoperable An operation couldn’t be completed
because of a mechanical problem.
1. Reset the autoloader and retry the
operation.See Section 3.2 on
page 3-2 for reset instructions.
2. If the error persists, contact your
service provider.
Hardware Error An operation couldn’t be completed
because of a mechanical problem.
1. Reset the autoloader and retry the
operation.See Section 3.2 on
page 3-2 for reset instructions.
2. If the error persists, contact your
service provider.
In Enet Mode The autoloader is executing a
command issued from the Remote
Management utility when a command
is issued from the operator panel.
Wait until the autoloader has finished its
current operation, then retry the
operation.
In Security Mode
Choice Rejected
Autoloader security has been set from
the application.
Disable autoloader security from the
application and retry the operation.
Media Removal
is Locked by Host
Media removal from the autoloader
has been prevented through the
application.
Turn off media removal prevention from
the application and retry the operation.
Over Temperature The tape drive’s temperature limit has
been exceeded, and the cartridge has
been ejected from the drive.
 Wait until the autoloader has cooled,
then unload the cartridge to a cell and
re-load it into the tape drive.
 Check the room temperature. The
ambient temperature must be no more
than 40°C (104°F).
 Provide additional air flow around the
autoloader to improve cooling.
POST Failed The autoloader encountered an error
during its power-on self-test.
Reset the autoloader. See Section 3.2 on
page 3-2 for reset instructions.
Sequential Mode An application tried to issue
commands to the autoloader while it
was set to Sequential mode.
Set the autoloader to Random mode.
(Refer to the Magnum 1x7 LTO
Autoloader Product Manual for
information about the autoloader control
modes.)
Servo Error The autoloader carousel has
experienced a problem.
1. Reset the autoloader and retry the
operation.See Section 3.2 on
page 3-2 for reset instructions.
2. If the error persists, contact your
service provider
Table A-1 Autoloader error messages (continued)
Error Message Description Corrective Action