Operating instructions

23-4
SCSI REFERENCE 1012975
CHAPTER 23—SEND VOLUME TAG (B6h)
Examples of valid templates are as follows:
23.3 COMMAND STATUS
The autoloader returns a status byte after processing the SEND VOLUME TAG
command. This section describes when each type of status byte might be
returned.
Good
The autoloader returns Good status when it is able to process the command
without errors.
Busy
The autoloader returns Busy status when it is processing a command for a
different initiator or when it is in the process of aborting a motion command.
Reservation Conflict
The autoloader returns Reservation Conflict status when it is reserved by a
different initiator. See Chapter 20 for more information about the RESERVE
command.
Check Condition
The autoloader returns Check Condition status for the following reasons:
 The message system is enabled and a message error occurs while the
autoloader is processing the command.
 The autoloader detects an unrecoverable parity error while receiving the
CDB or the volume tag data.
 The command is issued to an invalid LUN.
 A Unit Attention condition is pending for the initiator.
 The autoloader is not ready because the door is open.
 A reserved bit is set to 1 in the CDB or parameter list.
Template Matches
123?5678 12305678
12315678
and so on
123*5678 123___
(Any information starting with “123”; 5678 is ignored)