Instruction manual

Chapter 7
108 Exabyte 215M and 215A
2. In HyperTerminal’s Connection Description screen, enter a
name and choose an icon for this communications session.
3. In HyperTerminal’s Connect To screen, choose the
communications port you are using from the Connect Using
field. Click OK.
4. In the Properties screen, make sure the fields contain the
following values, then click OK.
 Bits per second: (baud rate of the computer)
 Data bits: 8
 Parity bits: none
 Stop bits: 1
 Flow control: none
5. Check the ASCII setup from HyperTerminal:
a. From the File menu, select Properties.
b. In the Properties screen, select the Settings tab.
c. In the Emulation mode field, select “ANSI.”
d. Click on the ASCII Setup button.
e. In the ASCII Setup screen, make sure none of the boxes
have check marks. Uncheck the boxes, if necessary.
f. Click OK in the ASCII Setup screen.
g. Click OK again in the Properties screen.
6. The Console program should now appear in HyperTerminal’s
main window. If necessary, type redraw and then press
[Enter] to refresh the screen.