Technical Manual

East Wind Technologies, Inc.
Copyright © 2022 East Wind Technologies, Inc. All rights reserved. 57/59
The upper 4 bits of IDm of System 0 is 0000b, so (for example), the upper 4 bits of IDm of System 1
becomes 0001b.
• Manufacture Parameter (PMm)
PMm consists of IC Code (2 Bytes) and the maximum response time parameters (6 Bytes).
o IC Code (2 Bytes)
This is the information to identify a product. IC code consists of two components, i.e., ROM Type and
IC Type.
o Maximum response time parameters (6 Bytes)
The timeout time is determined, based on the period of time necessary to process the commands.
Therefore (and because this period of time depends on the status of the card, and on the type and
content of each command), the Reader/Writer shall dynamically determine the timeout time. In FeliCa
technology, the maximum response time is determined by using the lower 6 Bytes of PMm. The card
provides this parameter to the Reader/Writer, enabling the Reader/Writer to dynamically determine the
timeout time.
3.10.3 Read Without Encryption
Function: Use this command to read Block Data.
Host sends:
Frame
0x2F
APDU command
Checksum
APDU: 0x10 06 01 2E 3D 23 BA 07 5C 45 01 09 00 01 80 00
Success:
Frame
0x2F
Response
Checksum
Response: Felica card answers.
Failure:
Frame
0xD0
Checksum
Example:
Send: 0x12 2F 10 06 01 2E 3D 23 BA 07 5C 45 01 09 00 01 80 00 37
Response: 0x1F 2F 1D 07 01 2E 3D 23 BA 07 5C 45 00 00 01 00 00 00 00 00 00 00 00 00 00 00 00
00 00 00 00 36
3.10.4 Write Without Encryption
Function: Use this command to write Block Data.
Host sends:
Frame
0x2F
APDU command
Checksum
APDU: 0x20 08 01 2E 3D 23 BA 07 5C 45 01 09 00 01 80 00 11 22 33 44 55 66 77 88 11 22 33 44
55 66 77 88
Success: