Technical Manual

East Wind Technologies, Inc.

operational use conditions

Any other usage conditions such as co-location with other transmitter(s) will need a separate

reassessment through a class II permissive change application or new certification.

2.4 Limited module procedures

Not applicable.

2.5 Trace antenna designs

Not applicable.

2.6 RF exposure considerations

The product comply with the FCC portable RF exposure limit set forth for an uncontrolled

environment and are safe for intended operation as described in this manual. The further RF

exposure reduction can be achieved if the product can be kept as far as possible from the user

body or set the device to lower output power if such function is available.

2.7 Antennas

The following antennas have been certified for use with this module; antennas of the same type

with equal or lower gain may also be used with this module.

Antenna Type

Integrated loop antenna

Antenna connector

N/A

2.8 Label and compliance information

The final end product must be labeled in a visible area with the following: “Contains FCC ID:

2AGMLEWTJ680H”. The grantee's FCC ID can be used only when all FCC compliance

requirements are met.

2.9 Information on test modes and additional testing requirements

Any co-located or simultaneous transmission with other transmitter(s) will require a separate

class II permissive change re-evaluation or new certification.

2.10 Additional testing, Part 15 Subpart B disclaimer

This transmitter module is tested as a subsystem and its certification does not cover the FCC

Part 15 Subpart B (unintentional radiator) rule requirement applicable to the final host. The

final host will still need to be reassessed for compliance to this portion of rule requirements if

applicable.

As long as all conditions above are met, further transmitter test will not be required. However, the OEM

integrator is still responsible for testing their end-product for any additional compliance requirements

required with this module installed.

IMPORTANT NOTE: In the event that these conditions can not be met (for example certain

laptop configurations or co-location with another transmitter), then the FCC authorization is no

longer considered valid and the FCC ID can not be used on the final product. In these

circumstances, the OEM integrator will be responsible for re-evaluating the end product (including