User`s manual

Ewave Stamper User’s Manual V1.0

short rubber antenna) is connected to the BASIC Stamp board, and the Base STAMPER (long

chrome antenna) is connected to the PC, but in fact the Mobile and Base units are interchangeable.

4. For best performance, position the STAMPERs such that their antennae are parallel to each

other and perpendicular to the Earth.

• While the range of the STAMPERs is 100 to 300 feet, initially it is recommended that you place

the STAMPERs a foot or so apart so that you may easily observe the LEDs of both STAMPER

modems simultaneously.

5. Apply power to the STAMPERs and the BASIC Stamp circuit board using the included AC wall

adapters. The Transmit LED should be on.

6. On your PC, test your system by invoking the BASIC Stamp Editor’s Identify command from the

Run menu.

• You should see the STAMPER’s Transmit and Receive LEDs flash as data is transferred over the

wireless link and you should see the correct Identification returned from your BASIC Stamp

module. If this does not work the first time, repeat the Identify command:Whenfirstpowered

up the STAMPER Modems need to synchronize. Because of this you may need to repeat the

Identify command several times when first powering up.

That’s it! You should now be able to download BASIC Stamp code and perform all normal debugging

operations with the STAMPER wireless link.