Quick Setup Guide

*1 Min 3Mins
10Mins 30Mins
Charge the battery
When scanner make 2 beeps or battery volume under 20% please plug the cable into
scanner and connect the other side with your device to charge power for it.
By scanning below barcode you can get the remaining battery volume.
Get Battery Rough Volume
 Red Light = Charging
 Green Light= Fully charged
Firmware Version:
Read below command barcode to check scanner’s firmware version.
Below programming barcodes are applied for version not lower than
B009NT_RFBTWCDE9220_W
Note: Please always provide scanner’s firmware version for reference when you
turn to service team for help.
Beep Type
Beep Sound
Indication