Quick Setup Guide

Apple: Connect Apple iOS Device (HID)
1.Power on the scanner. Blue LED light will start to flash.
2. Start a Bluetooth device search.
IOS: Tap Settings | General| Bluetooth. Turn on. A Bluetooth device search will begin.
3. In the device list, tap on “Netum Bluetooth”. Tap Pair.
4. The scanner will make one beep once it’s connected and LED light will turn to solid blue and is ready to scan.
Windows: Connect Windows PC(HID)
1.Power on the scanner. Make sure the scanner is discoverable (unpaired).
2. Use your computer’s Bluetooth Settings to connect to the scanner.
3. Open Devices and Printers and select “Add a device”.
4. In the device list, select “Netum Bluetooth”. Click Next.
5. Follow the remaining screens to complete the wizard.
Barcode Programming
Netum barcode scanners are factory programmed for the most common terminal and
communications settings. If you need to change these settings, programming is
accomplished by scanning the bar codes in this guide. An asterisk (*) next to an
option indicates the default setting.
*Important Notes: Many of the command barcodes only work with a scanner in a particular
Bluetooth or 2.4GHz mode as indicated by the header row of each table.
Factory Restore
Factory Reset will restore the scanner to Factory Default settings (configured as shipped).
Keyboard Language
If you use French Keyboard, scan barcode of “ French Keyboard”. Locate the cursor
on the place where you want to output the data then you can start to scan. American
Keyboard is set by default, if you use a US keyboard you can just ignore it.
* America EN keyboard French keyboard