Quick Setup Guide

Quick Setup Guide.
How to Start ?
There are three kinds of connections modes:
 USB Wired
 2.4GHz Wireless Connection
 Bluetooth Connection
Follow one of the following connection modes to get started.
 Working via USB Cable
①.Connect scanner with your device via USB cable.
②USB HID-KWB mode is set by default, if you want to work under virtual serial port please
refer to" USB COM (Virtual Serial Port)". (Page)
③. Set Keyboard language→See page () . US keyboard was set by default.
④. Locate the cursor on the place where you want the scanner to output the codes then you
can start to scan.
 Working via 2.4GHz USB Receiver (By default)
①.Scan " RF 2.4GHz Transmission". This mode was set by default , for first use please ignore
it.
②.Plug the USB receiver on your device.
③. Set Keyboard language→See page () . US keyboard was set by default.
④. Locate the cursor on the place where you want the scanner to output the codes then you
can start to scan.
*RF 2.4GHz Transmission
 Working via Bluetooth
①. Scan "Bluetooth Transmission".
②. Press scanner's button to power on the scanner.
③. Pair the bluetooth. →See page()
Bluetooth HID mode is set by default, if you want to work under SPP or BLE mode please
scan related command barcode from "Bluetooth Connection Modes" accordingly. (Page)
④. Set Keyboard language→See page () . US keyboard was set by default.
⑤. Open a file or software and locate cursor on the place where you want the scanner to
output the codes then you can start to scan.