Instruction Manual

*Please see separate Smart Switch Sub-Assembly
manual for complete instructions.
Smart Relay ×1
Fixing Screw
×1
Double Sided Foam
Pad
×1
Instruction Manual
×1
Product Introduction
Smart Relay uses Zigbee wireless technology and
may be used in different loads, including incandes-
cent lamps, halogen lamps, LED lamps and
fluorescent lamps. It is small in size and may be
installed in the box of light fixtures. This device is
compatible with standard Zigbee 3.0 gateway or
devices for remote control and inter-operation.
Technical Specifications
Model number SRB01
Input Voltage AC 85V~245V
Max. Load Power
AC 110V/300W
AC 220V/600W
Min. Load Power No limit
Type of Load Lighting
Operating Temperature
0~40°C
(32°~104°F)
Relative Humidity 5~85% RH
Wireless Connectivity Zigbee 2.4GHz IEEE 802.15.4
Zigbee Profile Zigbee 3.0
RF Characteristics
Operating frequency: 2.4GHz
Range: 30m~60m
Internal antenna
Product Size (L*W*H)
59.4mm * 39.3mm * 21.2mm
(2.34in. x 1.55in. x 0.83in.)
Device Identification QR Code (Zigbee)
Complete Accessories Include
Caution: Read this manual before attempting to install the device! Using this product in a manner other than
intended voids your warranty. Further, Focalcrest is NOT liable for any damage incurred with the misuse of this
product.
Caution: All installations of this device should be performed by a qualified or licensed electrician!
Caution: Product must be installed on a 10A line.
Caution: Metal casings, mirrors, electrical appliances, etc., may affect, reduce, or interfere with wireless
communication.
Installation Instructions
Caution: If you have purchased a Smart Switch Sub-Assembly
to use with it, please follow the installation instructions on the
Smart Switch Sub-Assembly manual.
With Smart Relay, you can turn a traditional lamp into a Zigbee
smart lamp. It is recommended to install Smart Relay near the
lamp.
Warning: Turn OFF electrical power from the breaker box or
electrical service panel before installing or servicing this
product. Improper use or installation can cause SERIOUS
INJURY, DEATH, or LOSS/DAMAGE OF PROPERTY.
Caution:
Use this product in
an indoor
environment.
N
L OUT 1
L
LOAD
N
N
L OUT
L
LOAD
You can choose one of the two diagrams below to connect the
wires according to your installation environment.
NOTES FOR THE DIAGRAM:
N - neutral wire L - live wire L OUT - output live wire
Stick the foam pad at the recommended position on the Smart
Relay and then place the relay on a flat, cleaned surface.
Turn ON electrical power and check if the wires are connected
correctly. If they are correct, the indicator light will be on when the
load light, the light(s) connected to the switch, is on.
Recommended
placement
2
Fix Smart Relay on a flat, cleaned surface
1
Connect wires per wiring diagram as follows
OUT
Output for load
Bottom
Wire Connection port
L
Power input for
live wire
N
Power input for
Neutral wire
Front
Indicator Light
Fixing hole
Fastening screws
RESET Button
Panel Connection port
Instruction
Manual
In-Wall Relay Switch
Smart Relay (Zigbee version)
Instruction Manual
Rev. A-031821 P/N SRB01