Configuration Manual

3.2.2. SD/HD Base Configurations
Introduction
The table below shows the available standard SD/HD configurations with an XTnano
server (with COHX or V3X boards), and how the BNC connectors should be cabled.
The XREC configurations, presented at the end of the table, make use of the secondary
link of the codec module of a record channel as an independent recorder. See also the
section "Channel Assignment in XREC Configurations" on page 57.
The XREC license (code 30) is only available with an XTnano server equipped with V3X
boards.
Available Configurations
IN4/OUT1 IN3/OUT2 IN2/OUT3 IN1/OUT4
#REC #PLAY
Prim.
Link
Sec.
Link
Prim.
Link
Sec.
Link
Prim.
Link
Sec.
Link
Prim.
Link
Sec.
Link
1 0 REC1
2 0 REC2 REC1
3 0 REC3 REC2 REC1
4 0 REC4 REC3 REC2 REC1
0 1 PLAY1
1 1 PLAY1 REC1
2 1 PLAY1 REC2 REC1
3 1 PLAY1 REC3 REC2 REC1
0 2 PLAY1 PLAY2
1 2 PLAY1 PLAY2 REC1
2 2 PLAY1 PLAY2 REC2 REC1
0 3 PLAY1 PLAY2 PLAY3
1 3 PLAY1 PLAY2 PLAY3 REC1
0 4 PLAY1 PLAY2 PLAY3 PLAY4
XREC configurations
2
3 PLAY1 PLAY2 PLAY3 REC1 REC2
4
1 PLAY1 REC3 REC2 REC1 REC4
4 2 PLAY1 PLAY2 REC2 REC4 REC1 REC3
58 3. Multicam Configuration
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013