Manual

nano series Servers - Version 11.01 – Operating Manual

EVS Broadcast Equipment SA – November 2012

Issue

11.01.C

9.8.2 Functions Available from the VGA Playlist

Screen

To use the following commands, you must be in Playlist Edit or Playlist Playout mode:

• To enter the Playlist Edit mode, press the PLST key on the EVS Remote. The LCD

screen of the Remote displays the information about the previous, current and next

three clips of the playlist.

• To enter the Playlist Playout mode, press the PLST key again.

The following operations can be performed from the VGA playlist screen:

Criteria Description

Naming a playlist For more information, refer to the section 9.6.1 ‘How to Name

a Playlist from the VGA Playlist Bank Screen’, on page 66.

Naming the current clip For more information, refer to the section 9.6.3 'How to Name

the Current Element in the Loaded Playlist’, on page 67.

PLAY/pause Press ALT+P to start the playback / pause of the playlist from

the current position.

RECUE Press ALT+R to recue to the beginning of the playlist and

pause.

NEXT Press ALT+N while the playlist is playing to force immediately

the transition to the next clip in the playlist.

SKIP Press ALT+S while the playlist is playing to skip the next clip.

The current clip will play until the defined OUT point, than the

playlist will skip the next one and play the one after instead.

9.8.3 Functions Available on the Remote in

Playlist Playout Mode

Once the playlist is cued and ready to roll, the menu below is displayed on the Remote

LCD. This menu gives the operator the ability to manipulate the playlist while it is playing.

The duration displayed in the top right corner of the LCD screen in Playlist Playout mode

is the remaining duration until the end of the playlist

PL11 LSM 04 Albert LOC LEFT=00:00:02:22

111A Clipname0123 00:00:29 Unk W00:10

112B/03 Clipname4567 00:53:29 Unk M00:10

112B Clipname8910 00:53:29 Unk M00:10

Film FX

Skip

Edit