Manual

Issue

11.01.C

nano series Servers - Version 11.01 – Operating Manual

EVS Broadcast Equipment SA – November 2012

Function Keys in the Main Menu

Select the corresponding Function key (F_ key), and then press ENTER to validate the

selection.

Function Key Use

F1 to F4 If desired, the Multicam system can be run using 1 or 2 EVS

Remote Panels. Depending on the number of play channels

available in the current configuration, 1- or 2- Remote modes

will be available from the main menu.

F1: 1 Remote One Remote Panel is used in the configuration

F2: 2 Remotes Two Remote Panels are used in the configuration.

F3: 3 Remotes N/A.

F4: 4 Remotes N/A.

F5: Char. On/Off Enables or disables the on-screen display (Timecode, Clip ID…)

on the output monitors.

F6: Exit Exits the Multicam software and returns to the EVS Menu.

F7: Clear all clips Clears all clips. All clips will be lost. A confirmation of this

command is required.

For more information to this action, refer to the section 8.2.6

‘Clearing Clips’, on page 37.

Note: This command is not similar to the Clear Video Disks

from the Maintenance menu. If you wish to refresh completely

the server, i.e. to clear all clips including the protected ones, you

need to use Clear Video Disks rather than Clear all clips.

F8: Stop Record

Stops the record. The REC key will go off and the F8 function

key is now used to restart the record.

F9: Fill Playlist «Dump» feature which allows all clips to be «dumped» at the

end of the current playlist. This allows the operator to save all

material to tape, as a backup feature after a show is complete.

You can select in the Setup menu which camera angles have to

be included in the Fill Playlist function.

Make sure that the playlist you have selected is an empty one.

This function will append the clips at the end of an existing

playlist.

F0: Technical Setup

Gives access to the technical setup menu.

Important

In order to guarantee the validity of data and clips previously saved, it is advised

to properly exit the application by pressing ALT+Q and ENTER

from the

keyboard, or F6 and then ENTER from the Remote Panel. DO NOT TURN OFF

THE SYSTEM WHILE THE APPLICATION IS RUNNING.