User manual

3.2.3. Phase Definition Settings
Introduction
The Phase Definition settings are available on the Server tab in the server-based
application (1
st
page) and web-based application in the advanced mode.
The Phase Definition settings are highlighted in the screenshot of the server-based
application shown below:
SD (Standard Definition)
Description Allows adjusting the digital main phase of the mainframe for the
standard definition. The value is adjusted by steps of half pixels.
The values depends on the genlock type (See "Video and
Reference Settings" on page 44).
Values • If the Genlock type is set to ‘Blackburst’, the main phase for
SD can be adjusted by steps of half pixels (37 ns) between
- 12000 ns and +15000 ns.
• If the Genlock type is set to ‘Tri-Sync’ (only possible in HD
resolutions), the main phase for SD can be adjusted by
steps of half pixels (37 ns) between - 30000 ns and +32000
ns.
XT3 Server-Version 11.00-Configuration Manual
3. Multicam Configuration 53