User manual

Command description Command key
Resetting all values of all settings in all tabs for the
selected configuration
SHIFT+F5
Applying changes ALT+A
Leaving without applying changes ESC, ENTER
In the Web-Based Interface
The navigation and editing commands in the web-based interface are the commonly used
commands in a web-based interface. The command buttons available are the following
ones:
Command description Command key
Activating the Advanced display mode
Coming back to the Basic display mode
Applying changes
Canceling changes
3.1.4. Overview on the Setup Menus in the Remote
Panel
Introduction
When you work in LSM mode, the Technical and Operational Setup menus available on
the Remote Panel allow you to define:
• the commonly used technical settings in the Technical Setup menu
• all operational settings in the Operational Setup menu.
The values assigned to the settings are saved as soon as they are modified.
Accessing the Technical Setup Menu
To access the Technical Setup menu, proceed as follows:
1. If you are in Playlist mode, press RECORD first to exit this mode.
2. Press F0 to open the Technical Setup menu.
The Technical Setup menu opens on the 1
st
page.
The Technical Setup menu is divided in sections and subsections, named by Tx.y where
x is the section number, and y the subsection number.
In all sections dedicated to a tab of the Multicam Configuration window in this manual, you
will find an overview table that lists the settings available in the Technical Setup menu, as
well as the sections where you will find them.
40 3. Multicam Configuration
EVS Broadcast Equipment S.A. -November 2011 Issue 11.00.C