Manualshelf

User manual

ManualsBrandsEVS ManualsComputer equipmentXT-3
41424344454647484950
Accessing the Multicam Configuration Window
In the Server-Based Application
To access the Multicam Configuration window from the Multicam Setup window when the
server is not running, proceed as follows:
1. Press the UP ARROW or DOWN ARROW key to respectively move up and down in
the list of configuration lines until the requested line is highlighted.
2. Press F8.
The Multicam Configuration window window opens.
To access the Multicam Configuration window from the Clips or Playlist window when the
server is running, press SHIFT+F2.
In the Web-Based Interface
To access the Multicam Configuration window from the Multicam Setup window when the
server is not running, click the Edit icon for the configuration line you want to
configure. The Multicam Configuration window opens.
The Multicam Configuration window will directly be displayed on the web-based interface
when the server is running a given configuration. You will directly be able to edit the
settings for the running configuration.
Display Mode
The settings in the Multicam Configuration window have been categorized as basic or
advanced settings depending on whether they are commonly used or not.
Two display modes are consequently available:
• Basic mode
• Advanced mode
Selecting the basic mode will hide settings on some pages, or completely hide other
pages.
To change the display mode in the server-based application, press F3.
To change the display mode in the web-based interface, click on the display mode label
or .
User Interfaces
Server-Based User Interface
The following screenshot presents the 1
st
tab, and 1
st
page of the Multicam Configuration
window in the server-based application, shown in Advanced mode:
• The title bar displays the selected configuration, and specifies whether the
configuration has been launched (running) or not (not running).
• The selected tab is highlighted in rose
• The current page and number of pages in the tab are specified in the top right corner.
XT3 Server-Version 11.00-Configuration Manual
3. Multicam Configuration 37