User manual

3. Multicam Configuration
3.1. Overview on User Interfaces
3.1.1. Introduction
Preliminary Remarks
Prior to using Multicam, the operator should set all necessary parameters in the Multicam
Configuration window. If clips are stored with certain parameters and the operator wishes
to change them afterwards, those clips and playlists will not change. It is thus important to
set these parameters first.
Most parameters are factory preset, and should not be modified without advice of qualified
EVS staff. Improper values for some parameters will prevent the proper operation of the
system.
General Comparison Between User Interfaces
You can configure the EVS server using one of the three available user interfaces:
• Multicam Configuration window in the server-based application
• Multicam Configuration window in the web-based application
• Technical and Operational Setup menus in the Remote Panel
The Multicam Configuration windows in the server-based and web-based application are
almost identical.
In the Remote Panel, however, only the most used technical settings are available in the
Technical Setup menu, and all operational settings are available in the Operational Setup
menu.
The following table provides an overview on the features available in each user interface:
Configuration Window
Technical
Settings
Operational Settings
Server-Based
Application
Yes
(tabs 1-6)
Yes
(tab 7)
Web-Based
Application
Yes
(tabs 1-6)
Yes
(tab 7)
Remote Panel Yes (partly)
(Technical Setup: F0)
Yes
(Setup Menu: SHIFT+D)
XT3 Server-Version 11.00-Configuration Manual
3. Multicam Configuration 35