User manual

2.3.5. Setting the Server Date and Time
Introduction
The Set Date and Time command allows you to adjust the system time & date from the
Multicam Setup window in the server-based application. This is not available in the web-
based interface.
Note
When you have just launched a configuration, a window displaying the system
date and time gives you another opportunity to modify these parameters.
Supported Formats
The supported date format is DD-MM-YYYY, as shown in the example below:
• 15-03-2011 for March 15, 2011
The supported time format is hh:mm:ss, as shown in the example below
• 22:58:00 for 22 h 58 min 00 sec (24-hour display)
A warning message will inform you if the format you try to use is not valid.
How to Set the System Date and Time
To set up the system date and time from the Multicam Setup window, proceed as follows:
1. In the Multicam Setup window, press T to call the System date and time command.
The following window opens:
2. In this window, type:
◦ the date in the DD/MM/YYYY format
◦ the time in the hh:mm:ss format (24-hour display)
using TAB to move from one field to the other.
3. Press ENTER to apply the changes to the system date and time.
The date and time you have entered here will automatically be taken into account when
you launch a configuration.
20 2. Multicam Setup
EVS Broadcast Equipment S.A. -November 2011 Issue 11.00.C