User manual

2.3.4. Setting the Server LAN PC Address
Introduction
The MTPC board of an EVS server allows interaction with other EVS hardware on a setup
via the LAN PC address. The port #1 of the MTPC board is used. The communication is
established through telnet or FTP access. XNet Monitor will also use the LAN IP
connection to transfer the monitoring data.
Note
You can only define the settings associated with the LAN PC address from the
server-based application.
Settings
The MTPC board connection settings are described in the table below:
Setting Description
IP Address Specifies the IP address to connect to the port #1 of the MTPC board on
the server. The IP addresses 0.0.0.0 and 255.255.255.255 are not
allowed.
Subnet Mask Specifies the range of logical addresses within the address space
assigned to the MTPC board connection.
Default
Gateway
Specifies the IP address of the router on the network that the MTPC
board can use as an access point to external networks.
How to Set the LAN PC
To set up the LAN PC on the EVS server, proceed as follows:
1. In the Multicam Setup window, press L to call the Set LAN PC address command.
The following window opens:
2. In this window, type the IP address, subnet mask, and default gateway using the TAB
key to move from one field to the other.
3. Press ENTER to validate the definition of the LAN PC settings.
The LAN PC settings will automatically be taken into account when you will launch a
configuration line.
XT3 Server-Version 11.00-Configuration Manual
2. Multicam Setup 19