User manual

Enabling Changes to Configuration Parameters
In the Server-Based Application
When the password protection is active, the following message is displayed in red at the
top of each configuration tab in the Multicam Configuration window:
To enable changes in the configuration parameters during the session, you will be
prompted for the password the first time you will save changes to configuration
parameters in a session.
In the Web-Based Interface
When the password protection is active, the Multicam Configuration window is
completely dimmed and a close lock icon is displayed at the top of the window:
To enable changes in configuration parameters during the browser session, proceed as
follows:
1. Click the Lock icon .
2. Enter the password on the dialog box that is displayed.
3. Press OK.
The close lock icon changes to an open lock icon , and the parameters can be
modified and saved for the browser session.
How to Deactivate the Password on the EVS Server
Once the password protection is active, it can only be deactivated from the server-based
application as follows:
1. In the Multicam Setup window, press W to call the Enable password command.
A message opens to warn you that you are about to remove the password protection:
2. Press the RIGHT ARROW key to select 'Yes' and press ENTER
3. Type the password in the dialog box that opens, and press ENTER to validate:
The password protection is directly removed from all user interfaces.
18 2. Multicam Setup
EVS Broadcast Equipment S.A. -November 2011 Issue 11.00.C