User manual

In the Web-Based Interface
To assign a server facility name in the web-based interface, proceed as follows:
1. From the Multicam Setup window, click Assign server facility name in the Tools
menu. A dialog box opens:
2. Type the server facility name and press OK.
The facility name is directly assigned and displayed in the title bar, as well as on the OSD.
2.3.3. Activating and Deactivating the Password
Protection
Activating the Password on the EVS Server
Introduction
The administrator can protect the EVS server with a password. This password protection
prevents unauthorized users from changing configuration settings. It does not prevent
from using operational commands.
The password protection can only be activated and deactivated from the server-based
application.
The password protection has the following impact on the various user interfaces:
• The password is required to apply changes to configuration parameters in the server-
based application and in the web-based interface.
• On the Remote Panel, the Technical Setup menu is not available.
How to Activate a Password on the EVS Server
To activate a password on the EVS server, proceed as follows:
1. In the Multicam Setup window, press W to call the Enable password command. A
warning message opens.
2. Read the warning message carefully. Press the RIGHT ARROW key to select 'Yes'
and press ENTER to activate the password protection.
The password protection is directly active in all user interfaces, for all configuration
parameters on all configuration lines.
XT3 Server-Version 11.00-Configuration Manual
2. Multicam Setup 17