User manual

2.3. Server Parameters
2.3.1. Chapter Contents
The table below presents the topics of this section and shows whether the described
features are available from the web-based interface and/or from the server-based
interface.
Commands Server-Based Web-Based
"Assigning a Server Facility Name" on page 16 Yes Yes
"Activating and Deactivating the Password Protection"
on page 17
Yes No
"Setting the Server LAN PC Address" on page 19 Yes No
"Setting the Server Date and Time" on page 20 Yes No
"Setting the Default Output To VGA/Video" on page 21 Yes No
"Configuring Server Raids" on page 21 Yes No
2.3.2. Assigning a Server Facility Name
Introduction
You can assign a facility name to the EVS server. It allows the identification of the EVS
server with a dedicated name, besides the server's serial number. This name is
independent from any configuration.
The server facility name differs from the server net name, which can vary from a
configuration to the other as it is defined in the configuration parameters.
The server facility name is displayed in the title bar of the Multicam setup and
configuration windows, as well as on the OSD (on-screen display).
In the Server-Based Application
To assign a server facility name in the server-based application, proceed as follows:
1. In the Multicam Setup window, press F to call the Assign server facility name
command. A dialog box opens:
2. Type the server facility name and press ENTER.
The facility name is directly assigned and displayed in the title bar, as well as on the OSD.
16 2. Multicam Setup
EVS Broadcast Equipment S.A. -November 2011 Issue 11.00.C