User manual
5. If requested, deselect lines you do not want to import:
◦ By default, all configuration lines present in the .lin file will be imported onto the
EVS server.
◦ To deselect a line, use the UP ARROWor DOWN ARROW key to highlight it in
green, and press SPACEBAR. The deselected lines turn light grey.
6. Press ENTER to validate the selection of configuration lines to import.
A warning message informs you about which configuration lines will be imported, and
tells the next screen will allow you to select which settings to replace.
7. Select 'Yes' using the RIGHT ARROW, and press ENTER.
8. In the Select settings to replace window, select the type of settings you want to import
for the selected configuration lines:
a. Press SPACEBAR to select or deselect a settings type.
b. Press TAB to move to the next settings type.
c. Repeat these steps for all settings types you want to import.
9. Press ENTER to start the import process.
In the Web-Based Interface
Note
In the web-based application, it is only possible to import configuration lines one
by one.
To import configuration lines onto an EVS server in the web-based application, proceed as
follows:
1. From the Multicam Setup window, click Import configuration lines in the Tools menu.
The Import configuration line window opens.
2. Click Select next to the top field and select the configuration file you want to import.
3. Tick the configuration line to be replaced on the EVS server.
4. Click Import.
The configuration line is imported with its original name onto the selected configuration
line on the EVS server.
XT3 Server-Version 11.00-Configuration Manual
2. Multicam Setup 13