User manual

2.2.5. Exporting and Importing Configuration Lines
How to Export Configuration Lines
In the Server-Based Application
Note
In the server-based application, the configuration lines are exported onto a USB
key. For this reason, you first need to insert a USB key on the USB port located
on the front panel of the EVS server.
To export configuration lines from an EVS server in the server-based application, proceed
as follows:
1. In the Multicam Setup window, press P to call the Export Configuration Lines
command. The Export Configuration Lines window opens:
◦ The left pane allows the selection of the configuration lines to be exported
◦ The right pane allows the selection of the location where the export folder will be
created on the USB key.
2. If requested, change the name of the folder the configuration lines will be exported to:
◦ By default, the folder name, displayed in the upper right corner, follows the
pattern: <server facility name_current date> where the date has the YYMMDD
format.
◦ To change the export folder name, type the requested name. You can do this any
time in the procedure.
3. If requested, change the selection of configuration lines selected for export on the left
pane:
◦ By default, all configuration lines are selected for export (orange font).
◦ To deselect a line, use the UP ARROWor DOWN ARROW key to highlight it in
green, and press SPACEBAR. The deselected lines turn white.
4. Press TAB to shift the focus to the right pane.
10 2. Multicam Setup
EVS Broadcast Equipment S.A. -November 2011 Issue 11.00.C