User manual

2.2. Configuration Lines
2.2.1. Chapter Contents
The table below presents the topics of this section and shows whether the feature
described is available from the web-based interface and/or from the server-based
interface.
Features Server-Based Web-Based
"Launching a Configuration" on page 7 Yes Yes
"Editing a Configuration" on page 8 Yes Yes
"Renaming Configuration Lines" on page 9 Yes Yes
"Exporting and Importing Configuration Lines" on page
10
Yes Yes
(one by one)
"Changing the Position of Configuration Lines" on page
14
Yes Yes
(indirectly)
"Copying, Pasting and Deleting Configuration Lines" on
page 14
Yes Yes
(indirectly)
2.2.2. Launching a Configuration
Introduction
When the EVS server has initialized, the Multicam Setup window stays open, by default,
until the operator selects the requested configuration line and launches it.
How to Manually Launch a Configuration
In the Server-Based Application
To start a configuration in the server-based application, proceed as follows:
1. Press the UP ARROW or DOWN ARROW key to respectively move up and down in
the list of configuration lines until the requested line is highlighted.
2. Press ENTER to run the configuration line on the EVS server.
In the Web-Based Interface
To start a configuration in the web-based interface, click the Launch icon next to the
configuration line you want to launch.
XT3 Server-Version 11.00-Configuration Manual
2. Multicam Setup 7