Operating Manual Manual

Issue

10.04.A

XSense

–

Version 10.04

–

Operating Manual

EVS Broadcast Equipment – January 2011

9.3.8 HOW TO NAME A CLIP

1. In the Clip screen, select the clip to name in one of the following ways:

• Click on the clip with the stylus

• Positioning the green arrows around the desired clip with the keyboard.

2. Type in the desired name with the keyboard. All characters available from

the keyboard are accepted, including blanks.

3. Press F1:

• In CAM mode, only the camera where the cursor is located is named.

• In CLIP mode, all cameras of the clip where the cursor is located are

named.

The entry in the Name field is not cleared by pressing F1 and remains for future

use. Press <BACKSPACE> to delete the last character in the Name field, or press

ESC to clear the whole field.

Note

To be able to name/rename clips on a network machine, the Clip Edit by

Network setting in the setup of the remote machine must be set to “Yes”

(VGA Setup screen) or “Enabled” (Setup menu on the Remote Panel). If

you are unable to name a network clip, please check this setting on the

remote machine.

9.3.9 HOW TO CHANGE THE PRIMARY CAMERA OF A CLIP

1. In the Clip screen, move the cursor to the desired camera.

2. Press F4 on the keyboard or click with the stylus on the corresponding area

in the Function bar.

→ This camera becomes the new primary camera.

→ If the selected camera is a secondary camera (indicated by “=”), it

becomes the primary camera and the previous primary camera becomes the

secondary camera.