Operating Manual Manual

XSense
–
Version 10.04
–
Operating Manual
EVS Broadcast Equipment – January 2011
Issue
10.04.A
127
11.16 SWAP AUDIO TRACKS
11.16.1 INTRODUCTION
The swap audio tracks mode allows swapping audio tracks between two points in a
playlist.
In four tracks mode, the “auto” mode replaces audio tracks 1&2 by audio tracks
3&4 in four audio mode. It replaces audio track 1 by audio track 2 in stereo mode.
The manual mode lets you choose which tracks to replace.
Note
In 8 and 16 tracks mode, you only have access to the manual mode.
11.16.2 HOW TO ENABLE THE AUDIO SWAP MODE
To enable the Audio Swap mode, proceed as follows:
1. Enter the Setup menu.
2. Select the Swap Audio Tracks mode on page 4.2, F3.
3. Choose a value between “Auto” and “Manual”.
Please note that the Split Audio Editing has to be enabled in the Setup menu
on Page 4.2, F1. This option requires a specific license code. If that code is
not installed on the server, this option cannot be turned on.
11.16.3 HOW TO PERFORM A SWAP AUDIO TRACK IN AUTO MODE
1. In Playlist Edit mode, select the Video Base mode (V Base). The LCD screen
will now display additional function:
2. Press the Swap button.
3. Jog your playlist until you reach the point where you want to change the audio
tracks. Mark an IN point.
PL11 LSM01 Paola LOC TDUR=00:00:02:22
111A/04 Clipname0123 00:00:29 Unk W00:10
112B Clipname4567 00:53:29 Unk W00:10
112B/02 Clipname8910 00:53:29 Unk W00:10
V Base A Base Swap
A Advanc A Delay A FX DUR A Split