User manual

Collective Editing Actions
You can apply the following editing actions to all audio channels of a page using the
following shortcuts, when available on the current page:
Command description Command key
Set all audio channels to Embedded CTRL+E
Set all audio channels to Digital CTRL+D
Set all audio channels to Analog CTRL+A
Set all audio channels to Embedded Dolby E or Digital
DolbyE
CTRL+Y
Set all audio channels to None CTRL+N
Reset all the audio configuration (also on other pages) to
default values
F5
Route all audio input channels of REC1 to the other record
channels (only audio inputs)
CTRL+0
Validating the changes ALT+A
Individual Editing Actions
To modify individual field/cell values (audio type or audio routing), use the general editing
commands that are described again below:
Command description Command key
Selecting a field value TAB
Scrolling down in the list of the possible values for the
selected field
SPACEBAR
Scrolling up in the list of the possible values for the selected
field
SHIFT + SPACEBAR
Modifying the Audio Gain and Mute Settings
Introduction
From the Advanced Audio Settings pages (3-6) of the Channels tab, you can not only
modify the default routing of audio channels, but also do the following:
• Adjusting the audio gain for each audio mono channel individually
• Muting individual audio channels
The audio gain and audio mute information is hidden by default. The CTRL+G command
allows you to toggle the display in the tables to show the audio gain and mute information.
114 3. Multicam Configuration
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013