User manual

Configuration Available from Server, Web and Remote
Panel
You can configure the EVS server using one of the three available tools:
• The server-based application (VGA) features all settings and commands for the setup
and configuration.
• The newly designed web-based interface is equivalent to the server-based application
and enables engineers to configure the EVS server remotely.
• The Remote Panel now includes:
◦ a technical setup menu that gives access to the most commonly used technical
settings.
◦ an operational setup menu that only provides operational settings.
The following table gives an overview on the features available in each user interface:
EVS Server Configuration
Setup Window
Configuration Window
Technical Settings Operational Settings
Server-Based
Application
Yes Yes
(tabs 1-6)
Yes
(tab 7)
Web-Based
Interface
Yes
(except some
Tools commands)
Yes
(tabs 1-6)
Yes
(tab 7)
Remote Panel No Yes
(Technical Setup F0)
Yes
(Setup Menu SHIFT+D)
1.2. Introduction to the Manual
Documented User Interfaces
The Server Configuration manual deals with all user interfaces used to configure
Multicam: server-based application, web-based interface, and Remote Panel.
• On the one hand, the information on navigability and editing commands, specific to the
user interface, is described in clearly separated sections.
• On the other hand, the reference information on and the description of configuration
parameters are described in common sections valid for all user interfaces. A clear
overview shows whether and where the parameters are available in each user
interface.
CONFIGURATION MANUAL XS Server 11.02
1. Introduction 3