User manual

EVS Multicam
–
Version 10.03
–
Configuration Manual
EVS Broadcast Equipment SA – July 2010
Issue 10.3.C
15
The following parameters can be defined:
IN LOOP
D-VITC The TC and user bits are always written on the SD outputs of the
record codec and are the same as on the source video.
Lines Lines on which the VITC must be written on the output connectors
of the record codec.
By default, these are lines 14-16 in NTSC and 19-21 in PAL.
SD OUT
D-VITC Field to specify if embedded timecode has to be inserted in the
output.
The possible values are:
No No new timecode inserted in the output.
In (default) Same timecode as in the input inserted in
the output.
LTC Timecode from the LTC table inserted in the
output.
USER User-defined timecode inserted in the output.
Lines Lines on which the specified timecode must be written on the
output.
UserBits Yes/No flag to specify if the user bits have to be included in the
output. The default value is ‘Yes’.
Clean VBI Field in which the use specifies whether the VBI needs to be
cleaned on the output.
The possible values are:
No The VBI is not cleaned in the output.
Always The VBI is always cleaned in the output.
If not OK The VBI is cleaned in the output if it is not
correct (play var mode, vertical split screen,
etc.)