User manual

Issue
10.03.C
EVS Multicam Version 10.01
–
Operating Manual
EVS Broadcast Equipment SA – July 2010
178
Setting Description Values
2
nd
Lever Secondary lever range to be applied for
playing back material recorded on the
hypermotion camera.
0-1000, +- 1000
(default)
18.2.3 KEY COMMANDS
The following table shows the various commands you can use on the Remote
Panel to control the hypermotion camera, as well as the corresponding command
on the hypermotion camera:
Command on
Remote Panel
Command on
hypermotion camera
Description
PLAY Play Initiates a replay on the current memory
block.
SHIFT-PLAY - Initiates a replay on the current memory
block at the speed defined in the
PGMSpeed parameter.
Mark Mark cue point With a single-block memory, it marks a
cue point of the current block.
This is not available on all cameras with
multiple-block memory.
Last cue Search With a single-block memory, it goes to
the previous cue point if cue points have
been defined.
With a multiple-block memory, it goes to
the previous cue point of the current
block if cue points have been defined on
this block.
When no cue point has been defined on a
block, it stops the recording and cues to
the first recorded frame.
RECORD Start ARM Initiates the loop recording on the current
memory block.
TAKE Trig/Stop rec With a single-block memory or when the
last block is reached, this stops the
recording.
With a multiple-block memory, it stops
the record on the current block and starts
automatically the record on the next
block.
Lever - Plays the material specified as secondary
lever range for the hypermotion function.