User manual

Issue
10.03.C
EVS Multicam Version 10.01
–
Operating Manual
EVS Broadcast Equipment SA – July 2010
176
18. Hypermotion Mode
18.1 INTRODUCTION
18.1.1 DEFINITION AND LICENSE CODE
Note
The hypermotion mode is a software option, which requires the license
code 20 being installed. For more information on the required license key,
contact the Support or Sales team.
The Hypermotion mode allows the server to control a hypermotion camera. Those
cameras record at a frame rate much higher than classical cameras. They use
record a buffer of image recorded in a memory of the hypermotion camera. This
sequence can then be ingested via the standard SDI connection into the server.
The hypermotion camera is considered as a normal camera by the server.
18.1.2 ACTIVATING THE HYPERMOTION MODE
To be able to access the hypermotion mode, you need to ensure that:
• You have the requested license code.
• You have activated the Hypermotion parameter in the setup of the Remote, on
page 6.4, F1. See also the Multicam Configuration manual.
• You have correctly selected the number of Remotes in the Main menu according
to the Remote mode defined in the setup of the Remote, on page 6.4, F3. See
also the XT Tech Ref Software manual.
Depending on the selected Remote mode, you will control the Hypermotion
camera only, or the hypermotion camera and a PGM of the server.
18.1.3 ACCESSING AND LEAVING THE HYPERMOTION MODE
• To access the Hypermotion menu, press SHIFT+D (HyperMo) in the operational
menu.
• To leave the Hypermotion menu or switch to the PGM control, press again
SHIFT+D in the operational menu. In Hypermotion + LSM mode, the D’ key
displays LSM Mode.