User manual

Issue
10.03.C
EVS Multicam Version 10.01
–
Operating Manual
EVS Broadcast Equipment SA – July 2010
102
11.10 ADDING & REPLACING CLIPS IN A
PLAYLIST
11.10.1 POSSIBLE METHODS FOR ADDING CLIPS
You can add clips to a playlist in different ways:
• Adding clips at the end of the current playlist without entering the Playlist Edit
mode.
See the section 11.10.3 ‘How to Quickly Add Clips to the Current Playlist’, on
pa
ge 102.
• Inserting clips before or after the clip selected in the loaded playlist.
See the section 11.10.4 ‘How to Insert Clips into a Playlist’, on page 103.
• Adding one or more clips returned by a search at the end of the current playlist.
See the section 11.10.5 ‘How to Insert the Result of a Clip Search into a
Pl
aylist’, on page 103.
11.10.2 MODIFYING A DISTANT PLAYLIST
Remote playlists are available as ‘Read Only’, and cannot be edited. If you want
to modify a network playlist, you have to create a local copy on your machine first.
This operation is done instantly if the clips remain in their original location. For
details about copying playlists, refer to the section 11.11 ‘Copying Playlists’, on
pa
ge 107.
11.10.3 HOW TO QUICKLY ADD CLIPS TO THE CURRENT PLAYLIST
You can create a playlist very quickly. The experienced operator can include a clip
at the end of the playlist containing an action that happened seconds before the
playlist is played on air. To add clips quickly at the end of the current playlist, you
do not have to enter the Edit mode.
To add clips to the current playlist, proceed as follows:
1. Activate a playlist as the current playlist.
For more information, refer to the section 11.4.2 ‘How to Activate a Local or
Di
stant Playlist’, on page 92.
2
. Recall the first clip for your playlist. For more information, refer to the
section 9.2.3 ‘Recalling a Clip’, on page 40.
3.
Press ENTER on the Remote Panel.
The clip is added at the end of the current playlist.
4. Repeat as many times as necessary until the last clip is entered.