User Manual Owner manual
Table Of Contents
- Table of Contents
- What's New?
- 1. Introduction
- 2. User Interface
- 3. Managing Channels
- 4. Loading Media
- 4.1. Introduction
- 4.2. Possible Loading Actions
- 4.3. Loading a Train or a Recording Ingest
- 4.3.1. How to Load a Train from the Channel Explorer
- 4.3.2. How to Load a Train or a Recording Ingest from the Database Explorer
- 4.3.3. How to Select a Train or a Recording Ingest from the Panel
- 4.3.4. How to Reload the Last Loaded Train or Recording Ingest
- 4.3.5. How to Load the Source Media of a Clip
- 4.3.6. How to Load the Train from the Previous or Next Recorder Channel
- 4.3.7. How to Select a Train with the ShuttlePRO
- 4.3.8. How to Snap back to the Last Loaded Train or Recording Ingest
- 4.4. Loading a Clip
- 4.5. Loading a Playlist
- 4.6. Loading a Timeline
- 4.7. Loading a Media with the Take Function in PGM/PRV Mode
- 5. Moving through Media
- 6. Creating Media
- 7. Editing Media
- 8. Publishing a Clip
- 9. Transferring Media
- 10. Exporting and Importing Playlists
- 11. Settings
- 12. Control Panel Shortcuts
7.4. How to Trim a Playlist Element
It is possible to modify the IN or OUT point of a playlist element. To do so, proceed as
follows:
1. Open the Control Panel and assign a player channel to it.
2. Load a playlist on the Clip-List tab.
3. Drag an element from the playlist onto the Loaded Media field.
The element will then be loaded on the Control Panel.
Control Panel interface elements which were dimmed become available. The Player
field background turns turquoise to highlight this situation.
4. Do one or both of the following possibilities:
◦ Define a new TC IN and click the IN button.
◦ Define a new TC OUT and click the OUT button.
5. Click the UPDATE ELEMENT button.
The element is modified in the playlist.
Note
If the original record train is still available, clicking the Ret button in the Control
Panel will load the media on the same frame than the loaded clip. This will allow
retrieving media outside the original clip boundaries.
7.5. Moving Elements Within a Playlist
To move elements within a playlist, you can choose to perform:
• Cut/Copy/Paste operations from the Clip-List tab in the Control Panel as described in
section "Playlist Grid" on page 36.
• A drag-and-drop operation within the Clip-List of the Control Panel.
Note
When you move a group within another group, only the clips of the group are
moved but the group is deleted.
When you move a group after the last clip of another group or before the heading
of another group, the group is moved with all its elements.
IPDirector- Version 6.2- User Manual- Control Panel
7. Editing Media 87