User's Manual Manual

1.7. Managing GPI in TLO
Introduction
On some occasions, users may want to apply a GPI when the TLOnowline is on a
specific timecode. As the TLOnowline and the TLEnowline are separated in time, users
must be able to define GPIs linked to the TLOor to the TLE. For example, the use of an
external device on the on-air channel needs to be triggered by a TLOGPI.
Warning
This should be performed by an appropriate technical staff as it involves a
DEBUG screen on the EVS Video Server.
How to Set the GPI Mode
To do so, proceed as follows:
1. On the EVSvideo server, go to debug screen by pressing CTRL+ALT+D, then go to
screen 440, page 12/12.
2. For the GPI you want to assign to the TLE, type CTRL+ the corresponding Function
key.
In the following example, type CTRL + F1
The timeline associated to the GPI 1 turns to TLE.
Changes not yet saved are highlighted in green.
3. Press CTRL + A to apply the change(s).
This information is stored in the setup and kept when re-starting the application.
16 1. Edit While Playout
EVS Broadcast Equipment S.A. - November 2012 Issue 6.00.A