User's Manual Owner manual

To move the nowline … Do the following:
by 10 frames to the left on
the timeline
Press the key.
OR
Press + (if no element selected)
by a requested number of
frames to the right.
Press (if no element selected)
+ requested number of frames on the numeric pad +
ENTER.
by a requested number of
frames to the left.
Press (if no element selected)
+ requested number of frames on the numeric pad +
ENTER.
6.4.2. Adding Mark IN and Mark OUT points
The mark IN point is symbolized by a green vertical line on the timeline.
The mark OUT point is symbolized by a red vertical line on the timeline.
The following table summarizes the various techniques to add mark IN and/or mark OUT
points:
To add … Do the following …
Mark IN
Place the nowline at the requested position and click .
Note:
If you have already defined a mark OUT point in the timeline and if you
position the nowline before the mark OUT point, the nowline will act
as a mark IN point when you perform an editing action.
Mark OUT
Place the nowline at the requested position and click .
Note:
If you have already defined a mark IN point in the timeline and if you
position the nowline after the mark IN point, the nowline will act as a
mark OUT point when you perform an editing action.
Mark IN and
OUT
(on the
boundaries of a
clip)
Place the nowline on a clip whose boundaries you want to define a
mark IN and mark OUT and click .
This works when no timeline element is selected.
IPDirector- Version 6.00- User Manual- IPEdit
6. Timeline 89