User's Manual User Manual

Issue 5.9.B IPDirector Version 5.9
–
User Manual
–
Part 1: General Workspace
EVS Broadcast Equipment – January 2011
110
LOADING MEDIA
Loading a Train
Possible Actions
You can load a train on the controlled player channel in one of the following ways:
• If the required recorder is assigned to a Function button, press this
corresponding Function button. The LED flashes red.
• In case a train is already loaded on the controlled player, you can press the
NEXT or the PREV button.
• To select a recorder channel not necessarily assigned to a Function button,
proceed as follows:
1. Press the SHIFT button and then the SEL REC button.
The list with the available recorder channels is displayed on screen.
2. Use the remote wheel to select a recorder.
3. Press the ENTER button of the remote
Note: To cancel the operation: press MENU.
The train is loaded on the player channel controlled by the remote or on the
Software Player.
Rules for Loading a Train
According to the element previously loaded on the controlled player channel, the
behavior will differ as follows:
Element Previously
Loaded
Pressing the F button of a recorder…
Playlist loads the corresponding train in E/E.
Clip loads the corresponding train in E/E.
Train in Pause loads the corresponding train in pause at the same
timecode.