User Manual Owner's manual

Issue 6.0.B
IPD Xedio Plugin Version 6.0 – User Manual
EVS Broadcast Equipment – January 2013
142
Button Description
The RET button is not available with the IPD Xedio plugin.
8.11.3 Trimming or Rolling Around the Clip
Transition
Introduction
The three upper buttons make it possible to trim around a clip transition. The following
table describes what the buttons are used for.
Button Description
The Trim OUT button allows the user to modify the OUT point of the clip
before the transition:
• by adding a frame to it when you click the button.
• by removing a frame to it when you press SHIFT and click the button
simultaneously.
The Trim IN button allows the user to modify the IN point of the clip after the
transition:
• by adding a frame to it when you click the button.
• by removing a frame to it when you press SHIFT and click the button
simultaneously.
This Roll Transition button allows the user to modify both the OUT point of
the clip before the transition AND the IN point of the clip after the transition.
This function ‘rolls’ the transition:
• on the right when you click the button.
• on the left when you press SHIFT and click the button simultaneously.
Activating the Trim Functions
These buttons are only available when the nowline is located on a transition common to
all selected tracks. For each track unused on the transition, the corresponding Track
Selection check box must be cleared.