User's Manual User guide

Issue 1.0.C
GX server – Version 1.0 – User’s Manual
EVS Broadcast Equipment – February 2011
18
4.2.4 SERVER STATUS INFORMATION
The following server status information is displayed on the right side of the Server
Control window.
The table below describes the status information fields:
Option Description
Disk Capacity
Remaining capacity on both Raw Materials and GX Clips
drives. It is expressed as a percentage of the total drive
capacity.
IP Address
IP address of the network interface card (NIC) that allows
the GX server to communicate over the network.
GX Software version Current version of the GX software.
Web Software
version
Current version of the GX web software
Genlock status Type and quality of genlock.
• The messages on the genlock quality can be the
following:
• Valid:
Good genlock
• Bad (no signal):
No genlock signal detected
• Bad (mismatch):
Genlock signal detected, but
not in the correct format
If the genlock quality is bad, the genlock information
is displayed in red. Otherwise, this is in green.
• The type can be ‘tri-level’ or ‘blackburst’.