User's Manual

Issue 1.63.C

Epsio Version 1.63 – User’s Manual

EVS Broadcast Equipment – May 2011

Special Effect p.9.2

[F1]Paint/Target OSD Monitoring: SD

[F2]Offside Line: On

[F3]External Offside: Off

[Menu]Quit [Clr+F_]Dft [F9]PgUp [F0]PgDn

4. Press F3 to access the External Offside setting and rotate the job dial to set

it to ‘On’.

This will display the IP Address setting.

Special Effect p.9.2

[F1]Paint/Target OSD Monitoring: SD

[F2]Offside Line: On

[F3]External Offside: On

[F4]IP Address: xxx.xxx.xxx.xxx

[F5]Default tool: Offside

[F6]Auto Mark: Off

[Menu]Quit [Clr+F_]Dft [F9]PgUp [F0]PgDn

5. Enter the IP address of the Epsio workstation as follows:

After entering the number for an octet with the function keys, validate by

pressing ENTER on the LSM Remote Panel.

6. Press MENU twice to go out of the Setup menu.

7. Press SHIFT+D to enter the Epsio menu.

The Epsio workstation should now be connected. In Epsio, the 2

and 3

lines

(which specify whether the corresponding IN connectors receive the video signal

from the EVS server in the requested video format) should have green icons, as

well as the 4

line (which specifies the IP addresses):

For more information on this Server Information area, refer to the section 1.3.3

‘Server Information Area’, on page 5.