User Guide Instruction Manual

ENGSoft v1.5
This document is the exclusive property of OpenCube Technologies SAS and cannot be reproduced or distributed without prior authorization
46 / 63
Figure 81: Create connection by dragging a link between source and destination pin

Youcandisconnectallthepinsofanaudiolayoutbyclickingonthe buttonontopofthelayout.Youcanreconnectall
thepinsofanaudiolayoutbyclickingonthe buttonontopofthelayout.
Figure 82: Disconnect all the pins of the 4 audio layout
Figure 83: Straight connect all the pins of the 4 audio layout
Saving an audio routing configuration
Eachlayoutmustbecompletelyconnectedtocreateavalidconfiguration.Theconfigurationmustbevalidinordertobe
saved.
Figure 84: If any pin is disconnected, the configuration is invalid and saving is prohibited

Thesavebuttonsarehighlightedwhenaconfigurationchangeshouldbesaved.
Figure 85: A visual hint reminds you to save your changes

Ifyouclickonthe[Save as...]buttonapopupwillappearallowingyoutochoosethenameoftheconfigurationtosave.An
interactivenamevalidationfeaturepreventsyoufromtypinganinvalidorduplicateconfigurationname.
Figure 86: The "Save configuration as..." dialog lets you choose the name of the configuration to save

Oncesaved,theconfigurationisappendedtotheavailableconfigurationlistandmaybeusedbyanyotherdestinationsub-
ject.Toassignapreviouslysavedaudioroutingconfigurationtothecurrentdestinationsubject,simplyselectitinthe"Cur-
rent routing configuration"combobox.