User Guide Instruction Manual

ENGSoft v1.5
This document is the exclusive property of OpenCube Technologies SAS and cannot be reproduced or distributed without prior authorization
33 / 63
Creating an MXF OP1A destination subject
n Select"MXFOp1a"inthe"Newsubject"dialogbox.
Figure 50: Selecting the new subject
n Afolder browserdialog willautomatically open.  Browseto thefolder whereyou want tostore youringested 
sequences.Youcanchangethedestinationfolderlaterbyclickingonthe buttononthetopoftheingestpanel.
Figure 51: Browsing the destination folder
Configuring an MXF OP1A subject
Youcanchangethesubjectoptionsbyclickingonthe buttononthetopoftheingestpanel.
ForMXFOP1Adestinationsubjectsyoucanconfigurethedestinationfilenamingrules.
Theseruleswillbeappliedasabasenameforallgenerateddestinationfiles. Youcanalsosettherulesdeterminingwhat
shouldbedoneifafilewiththesamenamealreadyexists.
Youcanselectfromamongthreedifferentfilenamingrules:
l "Source clip name"meansthatthebasenameofdestinationfilewillbethesameasthesourcefile.Forexample,if
thesourcefileisMyClip.mxfthenthedestinationbasenamewillbeMyClip.
l "Source user clip name"meansthatthebasenameofthedestinationfilewillbetheuserdefinedclipname(as
storedinthesequencemetadataifthereareany).Ifnouserclipnameisdefined,itisresolvedas"Notfound".
l "Following basename"meansthatthebasenameofdestinationfilewillbethetextstringprovided.

Twooptionsarepossibleintheeventofafileconflict:
l "Ask me"meansthatanerrorwillberaisedeachtimethereisaconflict,requestingyoutoselecttheappropriate
action.
l "Automatically increment filename"meansthatanordinalwillbeaddedtothenewdestinationfilebasename.For
example,ifafilenamedMyClip.mxfalreadyexists,thenewdestinationbasenamewillbeMyClip1andsoon.This
optionisautomaticallyselectedifyouuseafixedbasename,thusallowingyoutoingestorderedlistsofingests
(MyClip1,MyClip2...MyClipNlist).

Inthe"Destination start timecode"groupyoucanredefinethestarttimecodeoftheingestedfiles.See"Starttimecode
redefinition"onpage43.