User Guide Instruction Manual

ENGSoft v1.5
This document is the exclusive property of OpenCube Technologies SAS and cannot be reproduced or distributed without prior authorization
32 / 63
Figure 48: Browsing the destination folder
Youcanchangethedestinationfolderlaterbyclickingonthe buttononthetopoftheingestpanel.
Configuring a P2 Tree/Flat subject
Youcanchangethesubjectoptionsbyclickingonthe buttononthetopoftheingestpanel.
Figure 49: P2 Tree/Flat subject options
InP2Tree/Flatmodedestinationyoucanspecifyauserclipnamemanually forthedestinationsequence.Otherwisethe
sourcesequenceuserclipnameisused.
Inthe"Destination start timecode"groupyoucanredefinethestarttimecodeoftheingestedfiles.See"Starttimecode
redefinition"onpage43.
Inthe"Audio configuration"tabyouwillbeabletocustomizetheaudioroutingparametersofthesubject.See"Audiorout-
ing"onpage43.
12.2.2 MXF OP1A destination
Overview
MXFOP1AdestinationsubjectsallowyoutoconvertanysupportedsourcesequenceintoanMXFOP1Afile.Bydefault,the
resultingfilenameisthesourcefilename.Ifafilewiththesamenamealreadyexistsinthedestinationfolder,theappli-
cationwillasktheuserwhattodobydefault.Youcanchangethedestinationfilenamingpolicy,usingthesource'suser
clipnameorsetafixedfilenameasdestinationfilename.Youcanalsospecifywhetherornottoautomaticallyaddanincre-
menttothedestinationfilename.