User Guide Instruction Manual

ENGSoft v1.5
This document is the exclusive property of OpenCube Technologies SAS and cannot be reproduced or distributed without prior authorization
25 / 63
10.5 XDCAM Planning support
10.5.1 Overview
Inadditiontotraditionalclipmetadata,theSONYXDCAMstandardcanprovideauser-definedmetadatasetcalledtheplan-
ningmetadataset.YoucantakeadvantageofthisfeatureinENGSoftbyenablingtheXDCAM planningsupportoption. 
Whenthisoptionisactivatedyoucanbrowse,mapandingestplanninginformationinENGSoftlikeanyothermetadataset.
Only  one  user- defined  planning  set  can  be  used  by  ENGSoft  at  a  time.  If  you  want  to  take  advantage of  your 
XDCAMmaterialplanningmetadatayoushouldstartbycarefullydefiningtheinformationyouwillneedtoaccessinyour
planningmetadataanddesignit.ThissetalonewillberecognizedasthevalidplanningsetbyENGSoft.Ifyouwantusto
help  you  design  the  planning  metadata  that  best  fits  your  workflow  needs,  contact  us  at
[e-mail].
10.5.2 Enabling XDCAM planning support in ENGSoft
AnXMLschemafilewillbedesignedforyourspecificneedsandshouldbeinstalledtocompletetheconfigurationofENG-
SoftandenableXDCAMplanningsupport.
After  you  install  the  application,  you  will  have  to  manually  copy  the 
"XDCAMPlanningSchema.xsd"  file  that  has  been  provided  with  your  software  installer  in  the 
"C:\ProgramData\OpenCube Technologies\OpenCube ENGSoft"folder.
Figure 36: Location of the XDCAMPlanning schema to enable XDCAM planning support