Instruction manual

User’s Manual
56
⑪ Remote Setup: Click to change the settings of the camera by using the Remote Setup
screen.
⑫ Event Status Window: The event status window at the bottom displays a list of events that
were detected in the camera.
/
Alarm In On/Off Motion Detection Trip-Zone
Tampering Audio Detection
⑬ Screen Popup Menu: Clicking the right mouse button on the screen displays the screen popup
menu.
− Change Camera Title: Select to change the camera title.
− Enable Audio: Select to enable audio communication with the site
which the camera is installed and the audio control
panel appears.
Click the
button to send audio to the site which the camera is installed
and speak into the microphone. Click the
button to monitor live
audio from the site which the camera is installed through the attached
speaker. Clicking both the
and buttons allows two-way
communication. Clicking the
button disables audio communication.
− Aspect Ratio: Select to change the image aspect ratio displayed on the screen and the option
menu appears. Selecting Fit to Screen displays images by fitting them to the screen size.
Selecting Original Ratio displays images by fitting them to the screen size while maintaining
their original ratio. Selecting Half Size (x0.5) to Quadruple Size (x4) displays the images
at the selected image size.
− Multistream: Select to choose the desired stream if the camera is in multistream mode.
− Anti-Aliasing Screen: Select to enhance image display quality by eliminating stair stepping
(aliasing) effects in the enlarged image
.
NOTES:
 The image adjustment for the monitoring screen works only in the pause mode.
 A camera name change in the Web Watch mode does not affect the camera name set up
on the camera. Leaving the Camera Title blank causes the camera name set up on the camera
to display.
 Aspect Ratio – Half Size (x0.5) to Aspect Ratio to Quadruple Size (x4) in the Screen Popup
Menu will be enabled when the selected camera screen can display images in those sizes.