Instruction manual

User’s Manual

 Sensitivity: Set the motion sensitivity for daytime and nighttime independently. The higher the

number is, the more sensitive it is.

 Minimum Blocks for Detection: Adjust the minimum number of detection blocks that must be

activated in order to be considered as a motion event for daytime and nighttime independently.

 Motion Zone: Click the Setup… button and a motion detection zone setup screen appears. Define

the area (max. four) of the image that you want to set up a motion detection zone by using the

motion detection zone icons.

−

(Select) or (Clear): Click to select or clear a block for motion detection. You can select

or clear the several blocks of an area using the mouse dragging.

−

(One or All block): Click to select or clear one or all blocks at a time.

−

(Area): Click to select or clear several blocks of an area.

 Motion Ignoring Interval: Select the motion ignoring dwell time from the drop-down list. The

camera will not log or send notifications of motion events occurring during the preset interval

after a motion is detected. You can control excessive event logging and remote notifications

of motion detection events by adjusting the motion ignoring dwell intervals.

 Daytime: Set up the daytime range. The camera will consider the remaining time range as the

nighttime.

 Event Action: Check the box for each action the camera is to take when it detects a motion

detection event.

− Alarm Out: Check the box to trigger an alarm-output signal.

− Send Email: Check the box to send an email. Selecting Image Attachment attaches an event

detected image file (.JPG) to the email.

− Remote Callback: Check the box and select the remote systems to send a message (Not

supported for the WebGuard program).

− Audio Alarm: Check the box and select the audio file (.wav) to sound.

− FTP Upload: Check the box to upload images to an ftp server.

− Record: Check the box to record video

NOTE: You must properly configure the settings related to each event action when setting them

up to enable event actions. Refer to the Event Action setup.