Instruction manual

Network Camera
37
 Use Ignoring Time: Set up the event ignoring time. The camera will not consider tampering
that occurs during the preset time span as an event.
 Event Action: Check the box for each action the camera is to take when it detects a tampering.
− Send Email: Check the box to send an email. Selecting Image Attachment attaches an event
detected image file (.JPG) to the email.
− Remote Callback: Check the box and select the remote systems to send a message (Not
supported for the WebGuard program).
− FTP Upload: Check the box to upload images to an ftp server.
NOTE: You must properly configure the settings related to each event action when setting them
up to enable event actions. Refer to the Event Action setup.
System Event
Check the System Event box to set up a system event. The camera checks and reports the system
status.
 System Alive: Check the box to check the system operation, and select the check interval.
− Send Email: Check the box to send an email when the system is operating.
− Remote Callback: Check the box and select the remote systems to send a message when
the system is operating (Not supported for the WebGuard program)
.
NOTE: You must properly configure the Email and Remote Callback settings when setting them
up to send an email or a message. Refer to the Event Action setup.