Instruction Manual

49
4. Network Video Recorder Operating Instructions
1. Make sure the network video recorder is properly connected to the network (network cable and power
connection).
2. In the main interface of the network video recorder, click "Remote Device" -> Device Search -> Search
Camera, the interface will be displayed as shown in Figure 1-1.
Figure 1-1 Figure 1-2
3. Display the IP address you are looking for, for example 192.168.8.88, and the IP range is 8, if the IP range
of your network video recorder is the same as range 8, you can go directly to step 5, if not, you need to
adjust the IP camera segment to match your network video recorder.
4. Select the device, click the "Modify IP In Batches" button as shown in Figure 1-2, and then change both
the IP address and IP range of Gateway 8 to the same IP range that is consistent with the network video
recorder, click the "Confirm" button, and click the "Device Search " button again.
5. Click the "(Select All" button and then click the "Add" button, as shown in Figure 1-3.
Figure 1-3
6. Right-click to exit the interface and view a preview of the device renderer.