Troubleshooting guide

31
MANUAL REGENERATION
NOTE: For softeners, if brine tank does
not contain salt, fill with salt and wait
at least two hours before regeneration.
If you need to initiate a manual
regeneration, either immediately, or the
same night at the preprogrammed time
for regeneration (typically 2:00 AM),
complete the following steps.
For Immediate Regeneration:
Press and hold
REGEN until valve motor
starts (typically 3 seconds).
For Regeneration the same night:
Press and release
REGEN (notice that flashing “REGEN TODAY” appears).
ERROR
If the display toggles between “Error”
and an error code (i.e. a number), call
a service technician and report the
error code.
BYPASS VALVE OPERATION
To shut off water to the system, position arrow handles as shown in
the bypass operation diagram below. If your valve doesn’t look like
the diagram below, contact your service technician for instructions
on how to shut off water.
REGEN TODAY MON
GPM
2:408
PM
REGEN TODAY and TIME OF DAY
will flash alternately if a regeneration
is expected tonight.
NORMAL OPERATION BYPASS OPERATION
QUICK REFERENCE GUIDE:
GENERAL OPERATION
When the system is operating, one of six displays will be shown:
1. time of day/gpm
2. flow rate
3. vacation mode
4. capacity remaining
5. days to a regen
6. dealer name and phone number
Pressing
NEXT will toggle between the six choices.
TO SET TIME OF DAY
In the event of a prolonged power outage, time of day flashes,
indicating that this needs to be reset. All other information will be
stored in memory no matter how long the power outage.
1. Accessed by pressing
SET CLOCK
2. Adjust hours with + and — buttons, AM/PM toggles at 12
3. Press NEXT
4. Adjust minutes with + and — buttons
5. Press NEXT
6. Adjust current day with + and — buttons
7. Press
NEXT to complete and return to normal operation
ON VACATION
NO
FLOW RATE
GPM
8.0
TIME OF DAY MON
GPM
2:408
PM
DAYS TO A REGEN
GPM
3
8
CAPACITY REMAINING
GPM GAL
1600
8
PHONE NUMBER
DEALER NA
CURRENT DAY
SET
MON
TIME MINUTES
SET
TIME HOUR
SET
2:00
AM