Installation Guide

SLIP-FIT CONNECTION INSTALLATION
Use Slip-Fit Connection Install if:
• previous tub spout was a slip-fit
• water pipe extends more than 1.25" from wall
Parts needed:
Registration
Plate
Slip-Fit Clamp
(with set screw)
Spacing Tube Teflon Tape
Showerhead
Slip-Fit
Quick Connect
Back Plate
Slip-Fit Quick
Connect Receiver
(with set screws)
⁄
" Galvanized
Seal
⁄
" Copper
Seal
Trim Plate
(optional)
Tub Spout
Split Ring
(for ⁄
"
copper pipe)
pull
Tools needed:
flat head screwdriver
pipe cutter
phillips head screwdriver
hex key
(included)
pencil
1 (optional Trim Plate)
The trim plate is only needed if the existing hole
in the wall would not be fully covered by the
back end of the tub spout or the wall is uneven.
3
Slide the Spacing Tube over the water
supply pipe until it touches the
Registration Plate.